Navegação

4.1. Monitor IsoView

dimensions

The figure below shows the dimensions of the monitor. IsoView, with values ​​in mm.

connectors

The Monitor IsoView It has 6 connectors, 5 of them arranged behind the case, and 1 connector on the right side. The following image shows these connectors.

Connector Description Observation
CX6 communication connector, 6-pin circular model.
CX8 valve and sensor connector, 18-pin circular model.
  • Note: Compatible with cable connector labeled CX-8.
CX7 power connector, 4-pin circular design.
CX9 valve and sensor connector, 18-pin circular design.
  • Note: Compatible with cable connector labeled CX-9.
antenna connector GPS (GNSS) CX-3, model TNC 50 Ω.
Connector usb 2.0. Portable memory slot (pen drive)

Technical Data

Display LCD TFT active matrix
RGB
7” (152 × 91 mm)
800 × 480 pixels
Processor ARM® 32 bit Cortex® M4 cpu 180 MHz
RAM 64 MB SDRAM
Storage 8 GB
Approximate weight 1240 g
Temperature -20°C ~ 70°C
supply voltage 9Vdc ~ 16Vdc
Maximum current 42 A
Maximum Current in stand by < 100 mA
connectors 1 × 6-pin circular connector
1 × 4-pin circular connector
2 × 18-pin circular connectors
1 x Connector TNC 50 Ω
1 x Connector usb 2.0
Interfaces 2 x CAN 2.0B/J1939
1 x usb 2.0
Appetizer 4 x Digital/frequency inputs NPN/PNP (software configurable), max. 200 mA
used with:
- flowmeter
- Inductive sensor
1 x Input for function wake up
Departures 11 x H bridge outputs for spray valves, max 1 A peak (function dependent on license), with short circuit and over current protection. It has the capacity to control up to 11 motorized valves (2 wires, for a spray command with up to 9 section valves, 1 general valve and 1 regulating valve)
GNSS GPS+GLONASS L1
Cabinet ABS
degree of protection IP 65