8.2.10. Implement

*Screen type = Value Editing with Figure

*decimal places = 3
Minimum value = 1,000 m
Maximum value = 50,000 m

The Implement parameter configures the width of the agricultural implement used in the system operation IsoView. Allied with the parameter of Overlay, the width of the implement defines the distance between the parallel navigation guides that the machine must travel to fill the entire field area with the agricultural input being applied.

Below are some considerations about the implement parameter.

• If the parameter of Operation is configured as Spraying, the Implement parameter is shown with its value in meters, followed by the value of the Number of Nozzles between parenthesis. If the Operation is different from Spraying, the number of nozzles will not be displayed..

• If the parameter of Operation is set to Spraying, the Implement parameter value cannot be edited in the Work menu. Its value will be the result of the multiplication between the values ​​of the parameters of Number of Nozzles e spacing between nozzles. By clicking the edit button , the alert screen shown below will be displayed.

• if the Operation is different from Spraying, the implement width value editing screen will be displayed, as shown in the following image. The screen contains the self-explanatory figure of the meaning of the implement width parameter.