5.9. Diagnosis

• Installation

Before starting to use the IsoView for Navigation, it is necessary to check some information on the monitor screen referring to the satellites GPS from your position, to confirm that the system is ready and in conditions of use.

*In this step it will be necessary to turn on the monitor to check some parameters, see cover On, Assistant and Off in First steps. Next, it will also be necessary to go through the Setup Wizard.

Diagnosis Sequence

Item	Description	Action	Details
1	Move the machinery to an open field and make sure the signal antenna GPS (GNSS) it is in a location within sight of the satellites, with no buildings nearby.	Positioning machinery for local satellite reception.	-
2	Turn on the monitor and wait approximately 30 seconds for it to start.	Initializing the System IsoView.	On, Assistant and Off
3	If your system version IsoView, have enabled the Setup Wizard, the option to use it will appear on your screen, where you can select the:	confirm button and run the step-by-step completely.	Setup Wizard
		Cancel button and double tap to exit Setup Wizard.
4	Access from the Main Menu screen the Information and then on the screen satellites, touching the screen in:	1º Information Menu	Information > Satellites
		2º Satellite Menu
5	Satellite information screen	Wait a few minutes and check if the displayed data are close to the ideal values, according to the table below.	-
6	Information	Value	Details
	Data from GPS	GPS internal 1	Data from GPS
	Signal Quality	Excellent	Signal Quality
	HDOP	Less than 1.0	HDOP
	Used Satellites	greater than or equal to 8	Used Satellites
	Longitude	Value between -180.00000000 and +180.00000000	Longitude
	Latitude	Value between -90.00000000 and +90.00000000	Latitude
7	Confirmed that your equipment information is within the recommended System IsoView is ready.

¹ When the accessory Terrain Compensator is present, will be displayed GPS external

*Contact your local Dealership or our team Support and Technical Assistance in case of doubt.

*With the system installed according to the previous recommendations and all the information with values ​​close to those mentioned in this chapter, let’s learn to navigate following the step of First steps.