5.8. Battery Connection

• Installation

After visual check and the necessary adjustments, if necessary, we will check the condition of your battery before connecting the System.

!WARNING!
The Terminals of the Fuse Holder Cable GPS 12 WAYS AN20 must be connected directly to the battery. Do not use another point of the machinery to feed/connect this cable, as it may generate errors, loss of warranty or even damage the System.

Using a multimeter, perform the following procedure:

!Heads up!
Remember to take the necessary steps to ensure your safety and that of those around you..

*avoid surprises!
Check that the electrical system of the machinery can supply and maintain the Voltage and Current required for the accessories, mounted implements and lighting, test to ensure it is operating properly.

connecting to battery

!Before charging the tractor battery or carrying out any part welding procedure, always interrupt the connection between the tractor and the IsoView monitor, disconnecting the power cable CX-7 right behind the screen.

• Diagnosis