10.1. Configure a Machine

To carry out the settings of an agricultural machine in the system IsoView, including the tractor and the implement, some steps must be followed.

Tractor

“Work” settings”:https://www.manula.com/manuals/agres-sistemas-eletronico/isoview-30/2/en/topic/trabalho

1. Configure the name of Machine.
2. configure the Coupling Type.
   1. For Coupling Type = Fixed Coupling, configure the Implement Distance.
   2. For Coupling Type = Drawbar, to set up:
      1. Distance Antenna – Coupling.
      2. Coupling Distance – Implement Wheel.
      3. Coupling Distance – Bar.

Implement

“Work” settings”:https://www.manula.com/manuals/agres-sistemas-eletronico/isoview-30/2/en/topic/trabalho

1. Configure the width of Implement.
2. configure the Implement Sensor.
3. configure the Overlay.
4. configure the Lateral Displacement.

“Spray” settings”:https://www.manula.com/manuals/agres-sistemas-eletronico/isoview-30/2/en/topic/pulverizacao

1. For spraying implements, configure:
   1. Number of Nozzles.
   2. spacing between nozzles.
   3. Number of Sections.
   4. Number of Section Nozzles.