6.1.1. To connect

• First steps
• IsoView Configuration Wizard
• To switch off

turning on the monitor IsoView

After correctly following all the steps described in section Installation, let’s turn on the monitor IsoView.

*During the phase of Installation in step Diagnosis, will need to turn on the IsoView to check some parameters. Next, it may be necessary to go through the Setup Wizard.

Step	Action
1	press the black button positioned on the left side of the monitor to To connect.
2	A short beep will be heard, indicating that the system has powered up..
3	Wait approximately 30 seconds for the initialization process, where a screen containing the logo of the Agres.
4	Next, the loading screen of all system settings is shown..

Step	Action
4	If your system version IsoView, have enabled the Setup Wizard (to see Setup Wizard), you can select on the screen the:	confirm button and run the Wizard completely step-by-step.
		Cancel button and double tap to exit Setup Wizard.
5	At this point, you will be running the Setup Wizard, or it may have finished its execution.
6	Upon Completion of Setup Wizard or Cancellation of its initial execution, the System Initial Menu screen will be shown IsoView.

Home Menu	Details
	Information
	Navigation
	settings

*Congratulations, the system IsoView is ready to start its configuration and/or operation!