The Lateral Displacement parameter is used to configure the misalignment that exists between the center point of the implement and the longitudinal axis of the tractor. In operations with signal corrections of GNSS IsoPoint 3 and IsoPoint 4, the lateral displacement is a very important configuration to avoid failures and overlaps in the application in parallel guides. Mainly in these cases, the displacement value must be measured with the aid of a measuring tape.
Measured in meters, the lateral displacement value can be positive or negative. Positive values mean that the center of the implement is offset to the right of the tractor axle. Negative values mean that the center of the implement is to the left of the axis.
The image below shows the Lateral Offset parameter configuration screen, including the self-explanatory figure of its meaning.
