Using the parameter Type of Guide configured as Free, the user can generate the guides directly on the path taken by the machine in the field, making it possible to create as many guide lines as necessary. This way, the distance between the guides is not defined by the implement width and overlap parameters as for Straight and Curve..
The figure below shows an example of tabs of the type Free.
on the screen of Navigation, initially press the button to mark point A 
. At Map Area, a solid blue line will be drawn on the path taken by the tractor from the marked point A. Also shown is a Alert Board with the information Point A: OK. The figure below shows the screen for marking point A of the free guide.
After moving more than 20 meters from point A, the button for marking point B 
will be available on the navigation screen. If the button is pressed, the Alert Board with the information Point B: OK. In this way, the first free guide will be defined, and the guide line will continue to be shown in blue until the end of the marking by pressing the end free guide button 
.
After pressing point A, at any time it is possible to cancel the marking of the current line by pressing the free guide cancel button 
.
Once all the free guide lines have been properly marked, repeat the procedure using the mark point buttons A and mark point B , to end the free guide and it will be saved in the current field, press the end free guide button . The guide file will then be saved to the monitor’s internal memory. IsoView, and the line closest to the current coordinates of GNSS will be displayed as a solid red line, as shown in the following image..
With the free guide defined, the button to view the current location on the map of the free guide will be shown in the button bar on the right side of the navigation screen 
. By pressing the button, the Map and Current Location screen will be displayed, as shown in the figure below..
