The neuroTHERMAL measures bi-lateral skin temperature on both sides of the spine. The neuroTHERMAL uses two non-contact sensors that utilize thermal imaging technology. The Rolling Thermal sensors are activated by setting the Thermal Scan to one of three possible modes: Adult, Child or Infant. Setting the scan to Adult, Child or Infant is done by adjusting the wheel position on the Rolling Thermal Unit.
myINSiGHT™ supports three Rolling Thermal models:
- T4 – this is the latest generation of our wireless, Bluetooth enabled scanner. Most new users will have a T4 unit. This unit has an LCD screen on it, unlike the T3 (see below).
- T3 – the T3 is the wireless, Bluetooth enabled scanner also referred to as the BTRT.
- T2 – the T2 scanner is identical to the T3 scanner, except that it is wired and plugs into the INSiGHT™ base station.
- T1 – the T1 scanner is our legacy scanner which some users upgrading from INSiGHT™ 9.2 might have. This scanner has three sensors rather than two although only two are used at a time. If you are using a T1 scanner it is critical that you specify the correct patient body type (Adult, Child or Infant) in the software.