ConveyLinx Module status is indicated by several LED’s. All LED’s with the exception of the Ethernet Link and Activity LEDs are multi-colored and context sensitive. The following sections indicate the various meanings of all LED indicators.
If you need help finding where LED Items are located on the ConveyLinx Module
Communications
Indicator | Item | LED State | Description |
---|---|---|---|
Ethernet Left Link & Ethernet Right Link | OFF | No connection established | |
Solid Green | Connection is established | ||
Blinking Green | When data transmission activity is occurring |
Motors
Indicator | Item | LED State | Description |
---|---|---|---|
Motor Left & Motor Right | OFF | Motor is not running and no faults detected | |
Solid Green | Motor is running | ||
Solid Red | If Motor is running – indicates current limit If Motor is stopped – indicates motor is not connected properly or is overheated Power supply is under 18V or above 30V |
||
Blinking Red | Motor is overloaded and the module is limiting current to reduce temperature | ||
Flashing Red | Motor short circuit detected between at least two of the phase windings or Motor Power supply is less than 10V | ||
Solid Amber | Module is booting up | ||
Slow Blinking Red | Profinet enabled discover function initiated from PLC |
Network & Module Status
Indicator | Item | LED State | Description |
---|---|---|---|
Module Status | Blinking Red | Module is starting task processes | |
Blinking Green | Module is ready | ||
Flashing Green & Blinking Red | Module is in Failsafe Mode | ||
Flashing Red | Auto-Configuration is in progress | ||
Blinking Amber | Connection to peer lost or performing firmware upgrade check | ||
Solid Amber | Firmware upgrade in progress |
Sensors
Indicator | Item | LED State | Description |
---|---|---|---|
Sensors Left & Right | Solid Green | Sensor Input is energized | |
Solid Amber | Module is booting up | ||
Flashing Green | When in ZPA Mode and when Sensor is blocked – indicates external device (PLC/PC controller or EasyRoll) has accumulated the zone and inhibiting release | ||
Solid Red | Aux I/O Pin 2 is energized (when configured as an Input) | ||
Blinking Red | Arrival Jam or missing sensor | ||
Blinking Green/Amber | Sensor Jam | ||
Flashing Red | network Stop condition | ||
Flashing Amber | Power supply is less than 10V | ||
Slow Blinking Red | Profinet enabled discover function initiated from PLC |
Power
Indicator | Item | LED State | Description |
---|---|---|---|
Power | Solid Blue | Power supply for both Logic and Motors are connected | |
Blinking Blue | Motor power supply is less than 18V |
Special Cases
Indicator | Item | LED State | Description |
---|---|---|---|
All Sensor & Motor | Flashing Red | Module in stopped state | |
Left Sensor & Left Motor | Flashing Green | ZPA zone on Left side of module is in Maintenance Mode* | |
Right Sensor & Right Motor | Flashing Green | ZPA zone on Right side of module is in Maintenance Mode* |