2.2. Removing Protective Safety Shield

	To prevent injuries, the ATevo safety shield must always be installed when charger is in operation and/or energized.

2.2.1 Style-5070 Enclosure Instructions

• Standard Phillips head screwdriver is required.
• Open ATevo front panel door to access safety shields.
• Remove four (4) screws from corners of top shield and (4) screws from corners of bottom shield.
• Grab shield while removing the last screw, and gently remove.
• Reverse procedure for reinstalling the safety shields.
  

2.2.2 Style-5030 Enclosure
*Standard Phillips head screwdriver is required.

• Open ATevo front panel door to access safety shields.
• Remove six (6) screws from corners of top shield and (6) screws from corners of bottom shield.
• Grab shield while removing the last screw, and gently remove.
• Reverse procedure for reinstalling the safety shields.
  

2.2.3 Style-163 & Style-198 Enclosures

• Larger units not supplied with safety shields.