After confirming that all connections to ATevo are properly made, start up as follows:

  1. Turn ON (close) AC Input Circuit Breaker (CB1) first.

You should hear a soft hum from ATevo as output increases. ATevo LCD should start up and indicate dc output voltage. If the display does not light, do not proceed. Turn OFF (open) the AC Breaker (CB1) and recheck connections.

  1. Turn ON (close) the DC Output Circuit Breaker (CB2).

If any error codes or alarms appear on the Main ATevo Display and/or Alarm Indicator LEDs, refer to Section 8, Alarms & Indicators to interpret the origin and resolution of the indication before proceeding.

Last modified: 3 August 2023

Need more help with this?
Don’t hesitate to contact us here.

Thanks for your feedback.