14.3.9. Replacing Eliminator Filter Capacitor (C2) – optional

• See also Service Instruction (JD5078-02).

The optional eliminator filter (C2) consists of a single electrolytic capacitor with two (2) wires connected directly to the Power Board (A2).

Preparation:

• Shut down and lock out all power to ATevo.
• Remove safety shield and check with a voltmeter.
• Locate the ‘blue can’ capacitor (C2), at the bottom-left of ATevo, secured to the galvanized base with two (2) nylon zip ties.

Removal of Existing Capacitor:

• Cut the plastic ties and disconnect wires from the Power Board (A2).
• Remove the wired capacitor. Replacement capacitor (C2) is supplied with new wires and pre-crimped terminals.

*The pos(+) and neg(-) wires have different terminals to eliminate the possibility of connecting in reverse polarity.

Installation of Replacement Capacitor Assembly:

• Connect wires of new capacitor assembly (C2) to Power Board.
• Mount replacement cap to ATevo base with provided wire ties.
• Replace safety shield, and close front panel door.
• Restart ATevo.