In this section we will provide an example that will add a single module of each Mode to a project. This will require a combination of selecting the proper DAP from the Hardware catalog coupled with using the correct Profinet Name to achieve our desired result. The following chart lists the 6 modules we want to add to our project and the proper Device and Profinet Name syntax needed.
|Module Mode||I.P. Address||DAP from Hardware Catalog||Profinet Name|
|Full PLC Controlled||192.168.101.21||ConveyLinx-Ai||conveylinxplc-101-21|
|Reduced ZPA||192.168.101.22||ConveyLinx-Ai in reduced ZPA mode||conveylinxzpa-101-22|
|Reduced PLC Controlled||192.168.20.123||ConveyLinx-Ai in reduced PLC mode||conveylinxplc-20-123|
|Full ZPA with Merger||192.168.0.21||ConveyLinx-Ai||conveylinxzpa-0-21|
|ConveyLogix Interface||192.168.0.22||ConveyLinx-Ai in PLC mode with ConveyLogix||conveylogix-0-22|