12.1.1. ZPA Mode

In general, when you perform an Auto-Configure procedure, ConveyLinx Modules will configure in ZPA mode. If one sensor is connected (either Left or Right) and two motors are connected, the module is automatically configured as a single logical zone and will run both motors at the same time. If the modules are at factory default, both motors will be at factory default settings. Otherwise, the motor settings will be the ones last set by EasyRoll.

!Auto-Configuration of a two motor roller logical zone with an ERSC does not automatically cause both motors to adopt the same motor settings.

For Firmware 4.25 or ODVA Firmware 5.02 and EasyRoll version 4.19

For Firmware 4.27 and later or ODVA Firmware 5.07 and later and EasyRoll version 4.21