6.4.6. Using a Photoeye for Wake-Up

Because standard RJ-11/12 Sensors put their blocked/clear output on Pin 4; this type of Sensor can be plugged into the Upstream Control Port and provide the Pin 4 Wake Up signal

When PEx is plugged into the Right Control Port and its output is ON, Zone 1 will Wake Up if it is unoccupied. If Zone 1 is occupied, Zone 1 will not wake up and run

*If you do not have a Sensor with RJ-11/12 connector; you can use an SE-4 module to wire you sensor to the Control Port

*By default, your Sensor has to energize its output when it is blocked. You can change Pin 4 to accommodate a Sensor that de-energizes its output when it is blocked

!If your sensor has an Error or Health Output signal, you need to cut the signal wire for this on the RJ-12 connector in order to keep this signal from inadvertently energizing Pin 3