Connecting the EFT
1. Connect the EFT to COM1 on the Back of the Connectivity HUB.
2. Connect the Power cable to the EFT COM Cable
Configure the EFT
3. Swipe the NETS card in the terminal and Press 6 –1 –3 on the Terminal
4. ERC – Yes
5. Press Arrow down
6. Set the COM Type to RS232
7. Set the Speed to 9600 Baud – Make sure the Baud rate on the terminal, matched the on in Mos24Serial_Quadport.exe
8. Put the file Mos24Serial_Quadport.exe in C:\Install
- The file is provided to you by your provider.
-If You do not have the file call the technician Hotline.
9. Right click the File and press Run as Administrator
- User: .\administrator
- Password: P@sSw0rD
10. Press Change Port
11. Place the fles baxi.dll and baxi.ini in C:\gd90 on the POS
Newest baxi files can be found here: ftp://ftpportal.bbs.no/ Use internet explorer:
- Username: baxidistro
- Password: B4×1Di5T3#o
Navigate to:Baxi ->Baxi.ActiveX/Production Release -> 32bits x86/
Download then:BAXI.dll & baxi.ini
12. Open the CMD as Admin
- User: .\administrator
- Password: P@sSw0rD
13. Type in: cd \GD90 and press Enter
14. Type in: regsvr32 baxi.dll and press Enter
15. Press OK
16. Shut down the POS and turn it on after 30 sec (Reboot is not enough)
Post your comment on this topic.