Move a Device from a Sector to Another

1. Access the old sector
Normally, a device is associated to a fix sector. If you want to move a device to a different sector, please follow the steps below.

Access the old sector

If you want to access the sector by clicking Modify on the right side.

Or clicking on button on the top right when within the sector

2. Set an end date to the association
This is required as a device can only be assigned to one sector at once.

Set an end date to the association

Select the tab Associations. Within this area, the associations can be adjusted. The currently associated devices can be edited by pressing the tribar on the right side of the line. This allows to set an end date to the association.

3. Access the new sector

Access the new sector

The same as prior in the old sector you can access the sector by clicking Modify on the right side.

Or clicking on button on the top right when within the sector

4. Set a new association

Set a new association

Choose the sensors that you would like to associate to the sector, by clicking on the Associations Tab – then click on the Create Association button.

After creating a sector, you can associate a device to it by clicking on the button as shown in the following image:

Click in the serial no. field to choose your device for the sector.

Select or modify the start date and click on