Measurements

If the sector was set up for manual data, an additional tab will be available that allows for the creation of data points that either represent temperature or humidity.
The data can be added via the right side of this view and then either declined or approved for further processing via the two bottoms at the bottom of the measurements table.

In this tab the manual added data will be listed in a table with one of 3 different states.

The 3 different states are as follow:

Also visible in the table is the user responsible for the last change of state. Information of all changes with the responsible users can be found in the PDF report for the sector

*Items are marked per default as pending data and have to be approved before the system can handle them. Only approved data is processed.

Adding manual data

A manual data entry can be created on the right side of the measurement window

Approving/declining Data

The entered data can be approved on the bottom left side of the measurement window.

!Warning: The approval of the data has to be done in chronological order.

!Warning: The data has to be approved before it can be used by the system.

After selecting the action a popup will confirm if the action as successful