8.1.3.7. Minimum Pressure

*Screen type = Value editing

*If Flowmeter parameter is configured with value 0 (flowmeter disabled), the Minimum Pressure parameter will not be shown in the valve settings menu.

*Decimal places =1
Minimum value = 0.0 (parameter disabled)
Maximum value = 50.0 bar

The Minimum Pressure parameter allows the user to configure a minimum pressure value in bar, calculated by the IsoView system, with which spraying operation will be performed. Even if the read rate in L/ha is momentarily higher than the target rate, the system will not allow the pressure to fall below specified parameter value, thus meeting user’s application requirements.

The image below shows Minimum Pressure parameter setting screen.

*Minimum Rate Speed ​​operates in conjunction with Minimum Pressure and Minimum Flow.

!When using Minimum Rate Speed, Minimum Pressure and Minimum Flow, the equipment may apply a higher rate than desired if the configured values ​​are overestimated, which may generate phytotoxicity and/or insufficient spraying.