The system IsoView Excuse ISO 31has some sets of components, shown below.

Monitor installation

Item description
Monitor IsoView
Antenna cable GNSS
Antenna GNSS with magnetic base
Accessory for fixing the antenna GNSS with double-sided tape
Monitor power cable
Battery connection cable, with fuse holder
Trio of suction cups of the monitor fixing set
Monitor fixing set articulated arm
Portable memory

Connecting the monitor to the spray cable

Item description
Monitor IsoView
Cab spray cable
Spray cable extender, if necessary.
  • Available lengths: 5 and 10 meters.
Implement spray cable

Connecting the spray cable to the implement

Item description
Implement spray cable
Power cable for 3-wire or high-current valves, if necessary
Buffer connector for power cable entry, if not used
Valve output extender, if necessary.
  • Available lengths: 1, 3 and 5 meters.
Relay cable for driving high current valves, if necessary.
Buffer connector for valve outlet, if not used
Terminator cable for valves with model connector DIN 43650-B
Terminator cable for valves with model connector DIN 43650
Terminator cable for valves with model connector AMP Superseal 2-way 282080-1
Terminator cable for valves with model connector AMP Superseal 3-way 282087-1
Terminator cable for valves with Delphi 2-way connector
Terminator cable for valves with Delphi 4-way connector
Control of up to 9 section shut-off valves
Throttle
General valve
Sensor input extender, if necessary.
  • Available length: 3 meters
Terminator cable for sensors with Delphi 3-way connector, if necessary.
Terminator cable for ultrasonic sensors with connector M12 5 way, if necessary.
Buffer connector for sensor input, if not used
Flowmeter
Inductive implement sensor with 3-way Amp Superseal connector
Ultrasonic sensor for fruit growing with 5-way M12 connector
  • Up to 2 sensors