RaptorLinx-Ai-ST Controller / Power Supply & Wiring /

Power Supply Sizing

The current loading on the power supply for a RaptorLinx-Ai-ST depends upon the Current Limit setting(s) for the specific Motor Profile(s) defined in EasyRoll+.

For 48V Motor Power Supply:

Power Supply Current Load = Largest Current Limit Value from list of Motor Profiles × 1.2

For 24V Motor Power Supply:

Power Supply Current Load = Largest Current Limit Value from list of Motor Profiles × 2.6

For Separate Logic Only Power Supply

See Standby Current Consumption values for the power supply voltage you want to use for Logic Only Power in the Technical Specifications topic.

!Pulseroller assumes the user is aware of MDR power requirements for the application and that the user and/or installer have properly sized 24VDC / 48VDC power supplies and wiring based upon all applicable codes and standards. Pulseroller also assumes installation will follow proper equipment grounding practices. “DC common or -”on all power supplies should always be connected to ground. Improper power supply sizing and/or improper grounding practices may produce unexpected results