RaptorLinx-Ai-ST Controller / Controller Hardware /
Technical Specifications
| Input Power Supply Requirements | 18-26VDC for 24V Operation 36-50VDC for 48V Operation |
|
| Input Protection Rating | Class III | |
| Standby Current Consumption | < 200 mA without Motor for 24V Operation <100 mA without Motor for 48V Operation |
|
| Storage Temperature | -25ºC to 70º C ( -13ºF to 160ºF) | |
| Ambient Operating Temperature | 0ºC to 40ºC ( 32°F to 104°F) | |
| Humidity | 5% to 95% non-condensing | |
| Vibration | 0.152 mm (0.006 in.) displacement, 1G peak | |
| Mechanical Shock | 20G peak for 10ms duration | |
| Enclosure IP Rating | IP20 | |
| Weight | Approximately 250g | |
| Environmental Pollution | Class 2 | |
| Altitude | up to 2000m | |
| M8 Digital Inputs | Quantity | 2 Fixed 2 User Configurable |
| Minimum ON Current | 1.5 mA | |
| Maximum OFF Current | 0.4 mA | |
| Push-Pull Operation | User Selectable | |
| Switching Circuit | PNP / NPN Auto Detect | |
| M8 Digital Outputs | Quantity | 2 User Configurable |
| Output Voltage | 24V for both 24V or 48V Input | |
| Maximum Current | 200 mA per Output | |
| Discrete Terminal Inputs | Quantity | 5 |
| Minimum ON Current | 1.5 mA | |
| Maximum OFF Current | 0.4 mA | |
| Push-Pull Operation | Not Available | |
| Switching Circuit | Current Sinking | |
| Discrete Terminal Outputs | Quantity | 2 |
| Output Voltage | 24V for both 24V or 48V Input | |
| Signal Switching | PNP Source | |
| Maximum Current | 200 mA per Output | |
| Motor Port | Supported Motor Types | Raptor-Ai-ST |
| Motor PWM Frequency | 20 kHz +/- 0.1% | |
| Maximum Current | 7A | |
| Rated Current | User Selectable | |
| Motor Protection | ● Coil-to-coil short ● coil-to-Vcc short ● overheating ● over-voltage ● under-voltage |
|
| Network | Type | 3 port integrated Auto Duplex |
| Speed | Auto 10 Base-T / 100 Base TX | |
| Support | ● Auto MDI/MDI-X ● PAUSE Frame support ● Back pressure flow control |
|
| Supported protocols | ● Modbus-TCP ● Profinet-IO ● Ethernet-I/P ● CCLink IEF Basic |
|