General
 |
There is no equivalent setting in EasyRoll because these are determined by the Auto-Configuration procedure |
 |
Set up for master/slave motor rollers in a belted zone. There is no equivalent setting in EasyRoll |
 |
Sensor Debounce setting |
 |
Enable/Disable FlexZone operation |
 |
Change Upstream ConveyLinx Connection. If you want to perform the EasyRoll equivalent of selecting “None” for the connection, select the drop down option “Connect the the module with the below IP address” and enter “0” for each IP address octet. |
 |
Change Downstream ConveyLinx Connection. If you want to perform the EasyRoll equivalent of selecting “None” for the connection, select the drop down option “Connect the the module with the below IP address” and enter “0” for each IP address octet. |