There may be instances when you want to return a to its “factory default” state. The procedure to do this is the following:
- Unplug all sensors, devices, motors, and network cables such that the only thing connected is power
- Press and hold the Install Button until the Module LED begins to flash
- When the Module Status and Network Status LEDs both blink green, the procedure is complete
How to unlock a module with EasyRoll
Factory Default Settings
Item | Value or Setting |
---|---|
IP Address Settings | IP: 192.168.202.20 |
Subnet Mask: 255.255.128.0 | |
Default Gateway: 192.168.202.1 | |
Left & Right Motor Settings | Senergy ECO |
Normal Braking | |
Closed Loop | |
100% Speed | |
CW Direction | |
100 Pulses Acceleration | |
50 Pulses Deceleration | |
Module Mode | ZPA – 2 Zone – Left to Right Flow |
Singulation Release Mode | |
All Settings Options Unchecked |
Look Ahead & Timing Settings | JAM Timer = 5.00 |
Auto Clear Timer = 5.00 | |
Run After Timer = 5.00 | |
Sensor Debounce = 0.10 | |
All Induct Timers = 0.00 | |
Control Ports | All Options Unchecked |
Sensors | Sensors are “ON is Blocked” |
Sensor Health are “ON is Error” | |
Connections | All are Cleared |