|Imminently hazardous situation, which if not avoided, WILL result in death or serious injury.
|Potentially hazardous situation, which if not avoided, could result in death or serious injury.
|Potentially hazardous situation, which if not avoided, could result in minor or moderate injury (e.g. minor burns, bruising from pinch points, minor chemical irritation). May also be used to alert against unsafe practices.
|Important information not related to personal injury (e.g. messages related to equipment or property damage).
|LOCKOUT TAGOUT is required before servicing.
|VENTILATION MANDATORY. Maintain at least 6in / 152mm of free air on all vented surfaces for cooling. Allow sufficient clearance to open front panel for servicing.
|Refer to manual.
|SAFETY ALERT. Indicates that a hazardous situation exists. TO REDUCE RISK OF INJURY OR DEATH, refer to accompanying documents, and follow all steps or procedures as instructed.
| DANGEROUS HIGH VOLTAGE inside product enclosure.
TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK, do not attempt to open enclosure or gain access to areas where you are not instructed to do so. SERVICING IS TO BE DONE ONLY BY QUALIFIED SERVICE PERSONNEL.
|Allow at least 3 minutes for internal components to discharge to a safe level after performing lockout tagout to prevent exposure to DANGEROUS HIGH VOLTAGE.
|DANGER! Risk of Arc Flash (only for ATevo units with input voltage over 416 Vac)
|EXPLOSIVE GAS can be produced from batteries during normal operation. Never smoke, use an open flame, or create arcs in the vicinity of the ATevo or the battery.
|Do not operate equipment without all guards and/or covers in place.
Last modified: 10 May 2023