- For Style-5054, see also Service Instruction (JD5079-00)
- For Style-5070, see also Service Instruction (JD5079-01).
Steps:
- Shut down and lock out all power to ATevo.
- Remove safety shield, and check with a voltmeter.
- Locate the MOV Board (A9):
- Style-5054: bolted to top-left side of circuit breaker bracket
- Style-5070: mounted to center I/O panel
- Remove the two (2) screws that connect the Transformer (T1) primary wire lugs to the MOV Board (A9).
- Loosen mounting hardware, and remove old MOV Board.
- Install new (replacement) MOV Board (A9) onto breaker bracket.
- Reinstall mounting hardware to secure MOV Board to bracket.
- Reconnect Transformer (T1) primary wires to MOV Board (A9).
- Reinstall two (2) screws through lugs, and tighten nuts.
- Replace safety shield, and close front panel door.
- Restart ATevo.
Last modified:
12 September 2023