2.2. Removing Protective Safety Shield

	To prevent injuries, the ATevo safety shield must always be installed when charger is in operation and/or energized.

2.2.1 Style-5054 Enclosure Instructions

• A standard flat blade screwdriver is required.
• Open the ATevo front panel door to access safety shield.
• Remove the two (2) screws that attach the safety shield to the ATevo, one above AC Input Breaker (CB1), the other below theDC Output Breaker (CB2).
• Grab the safety shield on both left and right sides.
• Gently lift up and off of AC Input and DC Output Circuit Breakers.
• Reverse procedure for reinstalling the safety shield.
  

2.2.2 Style-5070 Enclosure Instructions

• Standard Phillips head screwdriver is required.
• Open ATevo front panel door to access safety shield.
• Remove four (4) screws from corners of top shield and (4) screws from corners of bottom shield.
• Grab the safety shield while removing the last screw, and gently remove.
• Reverse procedure for reinstalling the safety shield.