*Induct Reverse is only applicable for Reversing Control in ZPA Mode
Induct Reverse value is used in conjunction with Induct Forward when you are setting up Reversing Conveyor in ZPA Mode to cause the MDR to continue to run after the zone’s photo-sensor has been blocked when receiving a carton from upstream with reference to the “reverse” direction.
*Typically for Reversing Control, the Sensor is mounted in the center of the zone and the Induct Reverse Time/Distance is equal to the Induct Forward Time/Distance. These are adjusted separately so you can compensate for situations when you cannot put the Sensor in the center of the zone
Induct Reverse Time
| Enter new values for upstream and/or downstream Induct Reverse time and click the corresponding Set button. The default is 0 seconds and the valid range is 0 to 65 seconds. In our example we entered 0.5 seconds. The Set All button will apply these same settings for the range of modules indicated at the top of the dialog |
![]() |
Induct Reverse Distance
| Select Distance from the drop down box and enter new values for upstream and/or downstream Induct Reverse pulses and click the corresponding Set button. The default is 0 pulses and the valid range is 0 to 65,535 pulses. In our example we entered 300 pulses. The Set All button will apply these same settings for the range of modules indicated at the top of the dialog |
![]() |
* See Motor Pulse to Distance Calculation for details on figuring out the distance traveled
