5.4.1.1 Add CUCM Configuration

To add a new Configuration:

1. Go to Console Management => Configurations
2. Click Add to add a new Configuration.

3. Enter a Name and Description for the configuration.

4. Enter the Console Options password. This password is used to protect the local console configuration.

5. Enter the Cisco Communications Manager JTAPI information as shown below. You will need to validate the settings before they can be saved.

Server 1	Primary CM Server (Required)
Server 2	Secondary CM Server (Optional)
Server 3	Tertiary CM Server (Optional)
NAT 1	Primary CM Server (Optional) – If NAT is specified then system will ignore primary server IP and will use NATed Ip
NAT 2	Secondary CM Server (Optional) – If NAT is specified then system will ignore primary server IP and will use NATed Ip
NAT 3	Tertiary CM Server (Optional) – If NAT is specified then system will ignore primary server IP and will use NATed Ip
Application Username	CM Application User for JTAPI
Application Password	CM Application User Password

Copyright and Trademarks:

I. Copyright:

This website and its content is copyright © 2018 Akkadian, LLC. All rights reserved. Except with the prior written permission of Akkadian, LLC, any redistribution or reproduction of part or all of the contents of this website, including the redistribution or reproduction of any documentation or other materials downloaded from this website, in any form and in any media, is prohibited.

II. Trademarks:
Akkadian, the Akkadian logo and other trademark or service marks used on this website, whether registered or not, are the property of Akkadian, LLC and may not be used or reproduced without the prior written permission of Akkadian, LLC.

aPME UG 1/8/2018 0001 © http://www.akkadianlabs.com/apme/