The calibrations screen can be found by clicking the Calibrations button on the Advanced Device List view while in EDIT mode.
The Initial calibrations screen shows a list of current saved calibrations along with the number of device properties with that calibration assigned, the number of points on the calibration and the last date the calibration was added.
On the calibration row there are also an EDIT and DELETE buttons. A calibration can only be deleted when it is not currently assigned to any device property.
ADD CALIBRATION
A new calibration can be added by clicking the ADD button in the top right corner of the screen.
To create a calibration you must add a minimum of 2 points to the calibration plus a name.
Click SAVE to add the new calibration
EDIT CALIBRATION
Click the Edit button on the row for the calibration you wish to edit. This will open the configuration model with the current calibration values. Calibration points cannot be edited but must be deleted and a new point added with the correct values.
ASSIGN CALIBRATION
Calibrations are assigned to a device property on the Device Property Detail screen.
Post your comment on this topic.