Show multiple CAD-points

The ‘Show Multiple CAD-Points function uses the Flexijet 3D to aim at multiple CAD-points.A pause time between points can be specified when beginning the command, to give time to mark out a point before Flexijet projects the next point.

NOTE: This function should be used with 3D points. If projecting to points on a 2D-Plane, consider using Show Multiple CAD-Points instead.

To use ‘Show multiple CAD-points:

1. From the Flexijet tab, select ‘Show Multiple CAD-points (Perpendicular) from the drop-down of the ‘Show CAD-point’ menu.
   

2. Select the points to be displayed in your drawing, and press ‘Confirm’ or ‘Enter’. You may select by clicking, using selection boxes, or other techniques to select. Note that only points from a selection will be used.

3. Set the Standby time between points (how long for Flexijet to pause when displaying each point)

4. Set how many times to display the points. Ex: If set to 2, Flexijet will project all the points. After completing projecting the points, Flexijet will go back to the beginning and project all the points a 2nd time.

5. Flexijet will display each point perpendicular to the active plane. After reading the plane surface and compensating for variations, Flexijets laser will flash to indicate it is displaying the correct position of the point on the actual surface. After pausing for the specified time, Flexijet will continue to the next point.