Repositioning from points in Drawing and reality

This function allows a user to reposition/resume the location of their Flexijet by selecting 3 points in their drawing and measuring those 3 points in reality.

!This function may not produce results as accurate as the 3D locations repositioning function! This function should only be used if required, or if precision of repositioning is not important to the drawing!

To use this function:

1. Select the ‘Home’ or project folder.
2. Following the command prompt, use the mouse to click to select the 3 points that you will measure.
3. Now, measure those 3 same points in reality.
4. Recommend checking the accuracy of the relocation using the ‘Show CAD point’ function