Scale

With the Scale command, the selected object is scaled up or down by a specific factor. Enter the scale factor and the base point of the scaling.

• From the ‘Change’ tab, select the ‘Scale’ function.
  

• Select the object(s) to be scaled, and confirm with ‘Confirm’ or Enter

• Select the scaling point. The objects will be scaled around this point. A typical choice would be the front center point. Click or enter coordinates to set the scaling point.

• Now, enter the scaling factor. Then, press enter. To scale from mm to inches, a factor of 0.03937 is used. To scale from inches to mm, a factor of 25.4 is used. Then, press enter.

• The selected object(s) are now scaled.

*Note: Scaling and offsetting are different functions and will produce different results. For example, to insert a sink cutout, an offset should be used, not scaling.

Example: A sink DXF file is imported. The units were in mm, but the sink will be scaled to inches.