Autofade determines when a crossfade begins
Autofade Enabled (default)
With autofade enabled, a fade will start whenever a change to the source has been made.
Any changes to settings outside of the source will not trigger a fade. So, changing the Geometry or colour of a layer will not trigger a fade while changing the clip will.
Autofade Disabled.
Disabling autofade sets crossfade to a fully manual mode — a crossfade is started by pressing the take button.
Use this mode to set a complete state before applying it.
Disabling autofade creates a series of new controls:
Control
In manual mode, the layer controls will affect either the hidden layer, the visible layer or both depending on the control setting.
Take
Take starts a fade. Once started, a fade cannot be reversed.
Sync
Synchronises the visible layer to the hidden layer.
Post your comment on this topic.