Advertisim

2.2. Controller generic connections

CAN TYPE CONTROLLERS

Connect the signal wires High (H), Low (L) and ground ( ) of the control panel to the respective CAN inputs of the Advertisim.

INPUTS

General purpose digital inputs.

In order for the connection to the control panel is reflected in the device and the floors are displayed correctly indicate in Advertisim Manager the manufacturer of the controller and the type of connection. More information in the Advertisim Manager User Manual

BINARY CONTROLLER CONNECTION

  • Connector 1: Floor level indicator (Binary 1)
  • Connector 2: Floor level indicator (Binary 2)
  • Connector 3: Floor level indicator (Binary 4)
  • Connector 4: Floor level indicator (Binary 8)
  • Connector 5: Floor level indicator (Binary 16)
  • Connector 6: Floor level indicator (Binary 32)
  • Connector 7: Floor level arrow indicator up
  • Connector 8: Floor level arrow indicator down
  • Connector 9: Overweight
  • Connector 10: Doors blocked
  • Connector 11: Opening doors
  • Connector 12: Closing doors
  • Connector 13: Inspection
  • Connector 14: Out of service

SELECTOR

  • Connector 1: Pull-up binary inputs
  • Connector 2: Pull-down binary inputs
  • Connector 3: Resistor terminating bus RS485
  • Connector 4 y 5: Resistor terminating bus CAN

OUT

  • +5: 5v output to power external devices.
  • : Connect to controller mass or negative.

RS485 CONTROLLER CONNECTION

  • Match A and B-type connectors between the controller and the TCU.

MANIOBRAS DE TIPO CAN

  • Match Low (L) and High (H) connectors between the controller and the TCU.

NPN

  • +5: +5V output for parallel diode relay (included).
  • C: Collector NPN transistor

To display floor levels and directions correctly on your Advertisim screen you should fill out all required information in the Advertisim Manager device form (controller manufacturer and model). For more information see Advertisim Manager Manual.

After you connect the 12V power supply adaptor to a power outlet the screen will turn on. The process may take a few seconds. When your Advertisim screen turns on, you will see a similar image to the one shown on the right. If connectivity is available log on Advertisim Manager and start customizing your display.