COMPONENTS
A. All in One 10E
B. Antenna GSM (Optional)
C. Wireless USB Adapter (Optional)
D. USB Extender cable
E. 12VDC power adapter (Optional)
F. Converter DC/DC 24V/12V (Optional)
G. Die cut
CONNECTION DIAGRAM
INSTALLATION
1. Use the die included in the box to mark the anchor points and the necessary hole for the placement of the Advertisim.
2. Remove the die cut, drill the surface and place Advertisim in the desired location. Connect the antenna (if supplied) to the antenna connector (9). Locate the
antenna on the outside of the cabin (recommended roof), in order to improve signal reception.
3. Connect the Wireless USB adapter (if supplied) using the USB Extender cable into one of the inputs of the Advertisim (1). Connect the antenna and the power supply.
4. Make the connections to the controller.
5. Position the screen on the wall as shown in the picture.
6. Depending on the model purchased, connect the integrated power cable (10) to the power supply system of the installation (use the DC/DC converter, if applicable) or plug the adapter into a mains socket and connect it to the Advertisim (8).
7. Configure the devide using the Manager.
