There may be occasions during the Merge process where a Conflict is identified. In some instances, decision may be taken by the SAP team not to utilise ActiveControl Merge, but instead to manually rekey the source change into the target Development system.

In this situation, Mark as Manually Applied action can be used in the Transport Form to reflect that the Transport Form will not be merged.

When performing Mark as Manually Applied action, the user must indicate the Transport number of the Transport against which the manual rekey was done. Doing this ensures an audit of this manual rekey within ActiveControl (as the

Figure: Performing Mark as Manually Applied action via the Transport Form.

Figure: Related Merge section of the Transport Form shows the merge transport(s) for the source Transport Form.


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment