Adding the App to a Site

To use the Lightning Conductor App Part on a SharePoint® page, you first need to add the Lightning Conductor app to the site, where the page exists. There are many ways of adding an app to a site. The steps in this section, assume that the Lightning Conductor app appears under From Your Organization in the App Catalog. To add the Lightning Conductor app to the App Catalog, use the steps documented in the Installation of the App Package section of this online manual.

To add the Lightning Conductor app to a site, use the following steps. :

!You need to be mapped to the Full Control permission level to complete the following steps. If you are a Site Owner, then you will be mapped to this permission level.

1. Navigate to the site where you wish to use the Lightning Conductor App.
   
   
2. Click Settings in the top right corner of the team site, and then click Add an app.
   
   
   
   
3. On the Your Apps page, under Apps you can add, click Lightning Conductor.
   
   Tip: In your organization you may find the Lightning Conductor app below Noteworthy. If your organization has many apps, to quickly find the app, type Lightning in the Find an app search box.
   
   
   
   
4. On the Do you trust Lightning Conductor dialog, click Trust It.
   
   The Site Contents page is displayed, and the app will begin to install. It will first appear grayed during the installation, and then when the installation is complete you will see the app as displayed below.
   
   
   
   You can now start to use the app, by adding the Lightning Conductor App Part to a page, and configuring the App Part, as described in the in the Configuring the Lightning Conductor section of this online manual.

Related Office.com documentation

• Add an app to a site →
• Monitor apps for a site →
• Remove an app from a site →
• Permissions in Office 365 →
• Introduction: Control user access with permissions →
• Understanding permission levels →