Preparation for Inductor Removal:
- Shut down and lock out all power to ATevo.
- Remove safety shield.
- Disconnect the battery and dc load(s) from the DC Output Circuit Breaker (CB2+/-).
- Check with a voltmeter before proceeding, including any installed remote sense wires.
- Remove enclosure shroud.
- For Main Filter Inductor (L1), disconnect wires labeled ‘L1-1’ and ‘L1-2’ at Power Board lugs.
- For Secondary Inductor (L2), disconnect wires labeled ‘L2-1’ and ‘L2-2’ at Power Board lugs.
New Inductor Installation for All ATevos:
The Filtering Inductors (L1 & L2) are heavy. Be prepared to support their weights before proceeding. |
- Remove two (2) screws at top corners of the inductor mounting plate.
- Carefully lift the existing Inductor (L1 or L2) out of the bottom slots, and off of the enclosure back wall.
- Position new Inductor (L1/L2) with same orientation as existing.
- Slide inductor into bottom slots, making sure top mounting holes in plate align with holes on enclosure back wall.
- Install mounting screws into top corners of inductor plate.
- Route wires (natural leads) from inductor to corresponding lugs labeled on Power Board (A2).
- Insert wires into lugs and tighten.
- Check your work.
- Replace safety shield and close the front panel door.
- Restart the ATevo.
Last modified:
5 May 2021
Need more help with this?
Don’t hesitate to contact us here.