 |
To prevent injuries, the ATevo safety shield must always be installed when charger is in operation and/or energized. |
|---|
STEPS
- A standard flat blade screwdriver is required.
- Open the ATevo front panel door to access safety shield.
- Remove the two (2) screws that attach the safety shield to the ATevo, one above AC Input Breaker (CB1), the other below theDC Output Breaker (CB2).
- Grab the safety shield on both left and right sides, and gently lift up and off of AC Input and DC Output Circuit Breakers.
- Reverse procedure for reinstalling the safety shield.
Last modified:
1 March 2021
Need more help with this?
Don’t hesitate to contact us here.