Before changing the voltage selection jumper, shut down ATevo and lock out ac and dc power supplies. Turning off (opening) the ATevo internal circuit breakers does not eliminate live voltages inside the enclosure. |
STEPS
- Standard flat blade screwdriver is required.
- Follow instructions in Section 2.2, Removing Protective Safety Shield.
- Locate the multi-tap terminal block.
- Set locations of RED jumpers for desired ac input voltage, according to Section 2.3.2, Verifying Multi-Tap AC Input Voltage Setting.
- Carefully pry out jumpers in existing locations.
- Re-install jumpers into new (correct) locations.
- Re-check jumper locations and confirm jumpers are properly
seated.
Last modified:
18 July 2023
Need more help with this?
Don’t hesitate to contact us here.