Run [Test Reconfiguration]

How to automatically use [Test Reconfiguration] feature

Controller Tester automatically detects following modifications.

• When differ present project information from imported project information using [Import Project] feature.
• When differ present project information from imported test information using [Import test] feature.
• When detect source code modification after analyzing project.
  

When differ present project information from imported project information using [Import Project] feature

When differ present project information from imported test information using [Import test] feature

When detect source code modification after analyzing project

You can use [Test Reconfiguration] feature when Controller Tester detects source code modification after project analysis or reanalysis.

1. When the source codes modify, [Test Navigator] view indicates whether the change was made.
   

2. Select [Reanalyze] in project context menu or run tests to analyze the source codes.
   

3. Click [Yes] button in [Test Reconfiguration] dialog, then a dialog for recofiguration appears.
   

How to manually use [Test Reconfiguration] feature

If you click [No] button in [Test Reconfiguration] dialog or [Cancel] button while reconfiguration, following two method allow to use [Test Reconfiguration] feature.

• Select [Integrity Check] in pull-down menu of unit test view.
  

• Select [Test reconfiguration] to use [Test Reconfiguration] feature in function context menu or test context menu of unit test view.
  

*You can design a new test based on original test using [Test reconfiguration] feature.