Select a debugger in the [New Project] wizard of the target test project or [Target environment settings] of the project properties on Controller Tester. The list of selectable debuggers depends on the toolchain selected for the project.
When creating a project using the IAR toolchain, the debugger must be set to ide to use the IAR C-SPY debugging feature.
The fields to be set are displayed according to the selection. The fields for C-SPY are as shown in the table below.
Required fields are displayed in red in Controller Tester.
| cspy_debug_general_xcl_file_path | The path to the debug.general.xcl file required when using the IAR Embedded Workbench C-SPY debugger. When creating an IAR project, the project file (.ewp) is automatically created in the [setting] folder in the saved location. Required. |
|---|---|
| cspy_debug_driver_xcl_file_path | Path to the debug.driver.xcl file required when using the IAR Embedded Workbench C-SPY debugger. When creating an IAR project, the project file (.ewp) is automatically created in the [setting] folder in the saved location. Required. |
When the target environment settings are complete, click the [OK] or [Finish] button. Now you are ready to run the target test.
Need more help with this?
Don’t hesitate to contact us here.
