Renesas CS+ IDE

The target preference page is automatically filled in according to the tool chain selected by the user. The type of debugger you can choose depends on your toolchain analysis settings.

To build an Renesas CS+ IDE project, enter the required information in the Build tab of the target preferences and click Done.
The contents to be filled out are as shown in the table below, which is mandatory.

• Build tab
  

  ide_directory_path	Directory path of Renesas CS + IDE ex. C:\Program Files (x86)\Renesas Electronics
  ide_kind	IDE kind(CS+)
  workspace_path	This is only necessary for the Renesas HEW IDE, so you do not need to enter it in CS +.
  project_file_path	Project file path created by Renesas CS+(.mtpj)

If you click the Done button on the target preference page without writing all the contents or if the path has been changed, you can set it again at ‘Right click on the project in the test navigator-> Properties-> Test target-> Target environment’.

After setting the target environment and clicking the Run button in the unit test view, the controller tester builds the target test code.

*When exporting test codes from Controller Tester, some reference relative paths.
To reference this path when building in the Renesas CS+, add an environment variable.
- Add below paths at property of Build Tool-> Compile Options -> Preprocess -> Additional include paths
(CTWORKSPACE) \.metadata\.plugins\com.codescroll.ut.embedded\ CT project name \TestFixture
(CTWORKSPACE) \.metadata\.plugins\com.codescroll.ut.embedded\ CT project name \TestFixture\cs