ShiftLeft:Deep Impact Analysis (0060) is one of the most popular automated analysis checks within ActiveControl, allowing customers to identify missing dependent objects during the delivery of SAP changes.

It has been identified that utilising Virtual Targets as part of ActiveControl workflow highlighted that 0060 could not be used in the Inbox of a Virtual Target (or the preceding Target’s Test Queue or Outbox) as the analyser didn’t look at the subsequent ‘real’ SAP system target in the path. ActiveControl 9.10 introduces support for Virtual Targets as part of ShiftLeft: Deep Impact Analysis, via a new IGNORE_VIRTUAL_TARGET parameter. If the new parameter is enabled, the next active target in the path will be used as the target destination where Deep Impact Analysis will check for the dependency’s existence.


Configuration Steps

This new capability is enabled via new IGNORE_VIRTUAL_TARGET parameter as part of the Deep Impact Analysis (0060) analyser.



Figure: New IGNORE_VIRTUAL_TARGET parameter as part of the Deep Impact Analysis (0060) analyser.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment