Please Note – ConveyMerge works for ALL ConveyLinx Family Modules
| Module | Firmware |
|---|---|
| ConveyLinx-ERSC | 4.25 and later |
| ConveyLinx-HTF | 4.25 and later |
| ConveyLinx-Ai2 | 4.20 and later |
| ConveyLinx-Ai3-24-xx | 4.20 and later |
The following items are the prerequisites and constraints required to provide a fully functioning automatic conveyor merge:
- EasyRoll version 4.3 or greater
- Only (1) one Merge Zone is allowed for any given single module
- Merge Zone cannot have any Extension (slaved) zone
- All ConveyLinx modules controlling Merge Zone, Left Line discharge, Right Line discharge, and Center Line discharge must be in ZPA mode
- Left, Right, and Center Lines discharges cannot also be included in another instance of ConveyMerge