Allowing direct control the colour of each video map tile, Colour Blocks can be used to ‘bit map’ video mapped tiles from a lighting desk.
Configuring colour blocks
- The start address for colour blocks is set in the Viewport controls. Set this to the desired Art-net address.
- Colour Blocks uses Art-Net received from any sender irrespective of which NIC it is received on.
- Each tile is addressed based on the tile number.
- Each tile uses four DMX channels: Red, Green, Blue and Intensity (alpha),
- The intensity value acts as a mixer between the video and the colour; Intensity at full is all colour and at zero is all Video.
Note: Colour Blocks must be set to a different address than other Art Net receiving components in Hippotizer such as DMX or Multicontroller to avoid conflict. |
Colour block tile index can be edited in the video map. Select the tie(s) and choose the desired colour block index.
Hinterlasse einen Kommentar.