Auto Patch

The DMX component can automatically create a basic fixture patch that works in many scenarios.

To auto patch:

• Before beginning, ensure all hardware setup is complete. Any network ports and outputs should be attached and configured.
• Configure the Hippotizer system with the desired number of Layers, Mixes and Viewports
• Start the DMX Component and add it to a Pinboard.
• In the DMX Component, choose Auto Patch…

• The auto patch dialogue will open

• Choose the desired protocol
• Based on the protocol, select a starting universe.
• Auto patch can assign layers, mixes, viewports and timeline if required. Use the on/off switch to determine which to patch.
• Choose the desired personality for each fixture type.
• Press OK.
• The DMX component is now patched.