Check Documentation analyzer can be used to check if particular Document Categories have been attached/linked to a TE Business Task as part of the approval in a particular TE Control Point.

This can help to automatically check if, for example, a functional specification has been attached to a TE Business Task at the point a Dev Outbox approval is being performed, or if UAT Test Evidence has been
attached at the point a Production Inbox approval is being performed.

The Check Documentation analyser does not check the contents of the documents, it purely validates that the defined documents have been attached.

It is possible to check for a maximum of 5 different document categories in a particular control point.

Parameters
CATEGORY1 – populate with the document category that you want TE to check for in this control point
CATEGORY2 – populate with the document category that you want TE to check for in this control point
CATEGORY3 – populate with the document category that you want TE to check for in this control point
CATEGORY4 – populate with the document category that you want TE to check for in this control point
CATEGORY5 – populate with the document category that you want TE to check for in this control point

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment